2. Make sure that the fuel shutoff-valve is in the
“OPEN” position.
(1) Fuel shutoff-valve (A) Close
(B) Open
3.
Place the main-gear-shift-lever and the synchro-
shuttle shift lever in the “NEUTRAL” position.
(1) Main gear shift lever
(2) Synchro-shuttle shift lever
(A) Forward
(B) Neutral position
(C) Reverse
4. Place the PTO-clutch-control-switch in the “OFF”
position.
(1) PTO clutch control switch
(A) Push
(B) On (Engaged)
(C) Off (Disengaged)
5. Place the position-control-lever and the draft-
control-lever if equipped in the “FLOAT” position.
The “FLOAT” position is the lowest position of
position-control-lever and draft-control-lever.
(1) Position control lever
(2) Draft control lever (if equip-
ped)
(A) Down
6. Set the hand-throttle-lever to about 1/2 way.
(1) Hand throttle lever
(2) Foot throttle
(A) Increase
(B) Decrease
OPERATING THE ENGINE
To Next Page
Loading...
