Kyocera FS-1030D

2G6
1-5-17
(13)Image is partly miss-
ing.
Causes
1. Paper damp.
2. Paper creased.
3. Flawed drum.
Causes Check procedures/corrective measures
1. Paper damp. Check the paper storage conditions.
2. Paper creased. Replace the paper.
3. Flawed drum. Replace the process unit.
(14)Fixing is poor. Causes
1. Wrong paper.
2. Flawed press roller.
Causes Check procedures/corrective measures
1. Wrong paper. Check if the paper meets specifications.
2. Flawed press roller. Replace the press roller (see page 1-6-27).
(12)Offset occurs. Causes
1. Defective cleaning blade.
Causes Check procedures/corrective measures
1. Defective cleaning blade. Replace the process unit.