Kyocera FS-1030D

2G6
1-5-21
Clean with isopropyl alcohol.
Check visually and replace any deformed
rollers. See pages 1-6-5 and 1-6-6.
Repair or replace if necessary.
Clean with isopropyl alcohol.
Repair or replace if necessary.
Repair or replace if necessary.
Check the drawer claw visually and correct
or replace if necessary.
Change the paper.
Check visually and replace any deformed
guides.
Check visually and remedy if necessary.
Clean or replace the press roller. See page
1-6-27.
Repair if any springs are off the separation
claws.
Grease the bearings and gears.
Correct.
(1)
No primary paper feed.
(2)
No secondary paper
feed.
(3)
Skewed paper feed.
(4)
Multiple sheets of paper
are fed at one time.
(5)
Paper jams.
(6)
Abnormal noise is
heard.
Check if the surfaces of the feed roller and
MP feed roller are dirty with paper powder.
Check if the feed roller and MP feed roller
are deformed.
Electrical problem with the feed solenoid
(clutch) and MP feed solenoid (clutch).
Check if the surfaces of the upper and lower
registration rollers are dirty with paper pow-
der.
Electrical problem with the registration sole-
noid (clutch).
Deformed feed roller or MP feed roller.
Defective feed roller, MP feed roller or fric-
tion plate.
Check if the paper is curled.
Deformed guides along the paper conveying
path.
Check if the contact between the upper and
lower registration rollers is correct.
Check if the press roller is extremely dirty or
deformed.
Check if the contact between the heat roller
and its separation claws is correct.
Check if the rollers and gears operate
smoothly.
Check if the following electromagnetic sole-
noids are installed correctly: feed solenoid
(clutch), MP feed solenoid (clutch) and reg-
istration solenoid (clutch).
Problem Causes/check procedures Corrective measures
1-5-5 Mechanical problems