Kyocera FS-1030D

2G6
1-5-20
Problem Causes Check procedures/corrective measures
(13)
A paper jam in the
paper feed or exit
section is indicated
when the power
switch is turned on.
(14)
The LED indicator
requesting cover to
be closed is dis-
played when the
front cover is
closed.
(15)
Others.
A piece of paper torn from
copy paper is caught
around registration sensor
or exit sensor.
Defective registration sen-
sor.
Defective exit sensor.
Poor contact in the con-
nector terminals of inter-
lock switch.
Defective interlock switch.
Wiring is broken, shorted
or makes poor contact.
Noise.
Check and remove if any.
Replace registration sensor if indication of the corresponding
sensor is not light.
Replace exit sensor if indication of the corresponding sensor is
not light.
Reinsert the connector. Also check for continuity within the con-
nector cable. If none, remedy or replace the cable.
Check for continuity across switch. If there is no continuity when
the switch is on, replace it.
Check for continuity. If none, repair.
Locate the source of noise and remove.