EasyManua.ls Logo

Kyocera KM-2540 - Page 200

Kyocera KM-2540
208 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-12 Reference Information
U01821 A communication error occurred during reception at high transmission speed. Your unit may
not have the corresponding high speed reception capabilities. Perform reception procedures
again after having the transmitting party lower the transmission speed.
U02200 An F-Code Based Relay Broadcast Transmission command was received, but transmission to
the remaining final destination(s) was impossible because the destination FAX phone
number(s) that was(were) registered for the corresponding F-Code Relay Box in your FAX
machine has(have) been deleted. Check the information registered in your FAX and have the
initial transmitting station perform the transmission operation again.
U02400 An F-Code Based Relay Broadcast Transmission command was received, but was
unsuccessful because the F-Code Relay Box ID that the initial transmitting station entered did
not match the one registered in your FAX. Check the information registered in your FAX and
have the initial transmitting station perform the transmission operation again.
U03000 Polling Reception was attempted, but was unsuccessful because no documents had been
placed in advance in the transmitting party’s FAX. Check with the transmitting party.
U03200 The transmitting party’s FAX is one of our models and an F-Code Based Bulletin Board
Reception was attempted in order to receive documents from that party’s F-Code Box, but
was unsuccessful because there were no documents stored in the corresponding F-Code
Box.
U03300 An error has occurred due to one of the following reasons. Check with the other party.
(1) A Polling Reception was attempted in order to receive documents from the other party’s
FAX, but was unsuccessful because TX/RX Restriction was turned ON in the other party’s
FAX and the necessary password did not match.
(2)
The transmitting party’s FAX is one of our models and an F-Code Based Bulletin Board
Reception was attempted in order to receive documents from that party’s F-Code Box, but
was unsuccessful because
TX/RX Restriction
was turned ON in the other party’s FAX and
the necessary password did not match.
U03400 Polling Reception was attempted, but was unsuccessful because the password input in the
transmitting party’s FAX and the self-station ID of the receiving party did not match. Check
with the other party.
U03500 The transmitting party’s FAX is one of our models and an F-Code Based Bulletin Board
Reception was attempted in order to receive documents from that party’s F-Code Box, but
was unsuccessful because the F-Code Box number that you entered was not registered in the
other party’s FAX.
U03600 The transmitting party’s FAX is one of our models and an F-Code Based Bulletin Board
Reception was attempted in order to receive documents from that party’s F-Code Box, but
was unsuccessful because the F-Code password that you entered did not match the one
registered in the transmitting party’s FAX.
U03700 An F-Code Based Bulletin Board Reception was attempted in order to receive documents
from the other party, but was unsuccessful because the other party’s FAX does not have F-
Code Based Bulletin Board Transmission capabilities or because there were no documents
stored in the corresponding box.
U04000 The destination FAX is one of our models and an F-Code Based Confidential Transmission
was attempted in order to transmit documents to that party’s F-Code Box, but was
unsuccessful because the F-Code Box number that you entered was not registered in the
destination party’s FAX.
U04100 A transmission to a destination party’s box (ex. F-Code Box) was attempted, but was
unsuccessful because the destination party’s FAX does not have F-Code Based Confidential
Reception capabilities.
U04200 Encryption Transmission was attempted, but was unsuccessful because the Encryption Box
was not registered in the other party’s FAX.
U04300 Encryption Transmission was attempted, but was unsuccessful because the other party’s FAX
does not possess Encryption Communication capabilities.
U04400 Encryption Transmission was attempted, but was unsuccessful because the Encryption Keys
did not match.
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION

Table of Contents

Other manuals for Kyocera KM-2540

Related product manuals