Reference Information 8-13
U04401 Encryption Transmission was attempted, but the other party was not dialed because the
designated Encryption Key is not registered in your unit.
U04500 Encryption Reception was attempted, but was unsuccessful because the Encryption Keys did
not match.
U05100 Transmission was attempted, but was unsuccessful because TX/RX Restriction was turned
ON in your unit and the necessary communication conditions were not met. Check with the
destination party.
U05200 A transmission was attempted by another party, but was unsuccessful because TX/RX
Restriction was turned ON in your unit and the necessary communication conditions were not
met.
U05300 Transmission was attempted, but was unsuccessful because TX/RX Restriction was turned
ON in the destination party’s FAX and the necessary communication conditions were not met.
Check with the destination party.
U09000 Communication was attempted but, but was unsuccessful because the other party’s FAX
does not match the communication protocol in use (the other party is using a G2 facsimile).
U12000 An F-Code Based Relay Broadcast Transmission command was received, but all the data to
be transmitted was not received because the memory in your FAX machine has become full.
Check the contents of your machine’s memory and, after you have created sufficient space in
memory, have the initial transmitting station perform the transmission operation again.
U14000 A reception from an F-Code box was attempted, but was unsuccessful because the memory
in your FAX machine has become full. Print out data from memory and try again or abandon
the F-Code Based Confidential Reception attempt.
U14100 The destination FAX is one of our models and a transmission to a destination party’s F-Code
Box was attempted, but was unsuccessful because memory in the destination party’s FAX
machine has become full.
U19000 Memory Reception was attempted, but was unsuccessful because your memory has become
full.
Clear your memory of all other data and attempt reception again.
U19100 Transmission was attempted, but was unsuccessful because the destination party’s memory
has become full.
Check with the destination party.
U19200 The data stored in memory is faulty. Perform the necessary communication procedures again.
U19300 A transmission was attempted, but was unsuccessful because the data to be transmitted is
faulty.
Perform the transmission procedure again.
U19400 A reception was attempted, but was unsuccessful because the received data is faulty.
Perform the reception procedure again.
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
To Next Page
Loading...
