2GN/2GP/2GR-1
1-4-7
Optional
DP
78
Document processor
top cover open
The document processor top cover is opened during orig-
inal feeding.
The following switches turns on when starting the original
paper feed.
Original feed switch (OFSW)
Original registration switch (ORSW)
DP timing switch 1/2 (DPTSW1/2)
-
Optional
finisher
80
Jam between the fin-
isher and machine
(3000-sheet document
finisher only)
Paper ejection is not output from the machine to the doc-
ument finisher within specified time of the paper entry
sensor (PES) turning on.
15 s
81
Paper entry sensor
nonarrival jam
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned off even if a
specified time has elapsed after the machine eject signal
was received.
1360 ms (30 ppm)/
1052 ms (40/50 ppm)
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
1360 ms (30 ppm)/
1052 ms (40/50 ppm)
(3000-sheet document finisher)
The paper entry sensor (PES) does not turn off within
specified time of its turning on.
2989 ms (30 ppm)/
2313 ms (40/50 ppm)
(Document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
2627 ms
(Built-in finisher)
The paper conveying switch (PCSW) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
1573 ms (30 ppm)
1217 ms (40/50 ppm)
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is con-
veyed to the intermediate tray from the paper conveying
unit.
Paper length + 1123
ms (30 ppm)
Paper length + 869
ms (40/50 ppm)
82
Jam in stapler
(3000-sheet document finisher)
The home position is not detected within the specified
time when driving the staple motor.
600 ms
(Document finisher)
The staple home position sensor (STSPS) is not turned
on within the specified time when driving the staple motor
(STM).
1000 ms
(Built-in finisher)
The staple home position sensor (STHPS) is not turned
on within the specified time when driving the staple motor
(STM).
600 ms
Section Description Conditions Specified time
To Next Page
Loading...
