Lubrication 103
5. Once the sample is taken, remove the probe from the coupler and pull out the probe to remove it
from the bottle (see Figure 4-7).
Figure 4-7
Pulling out probe from bottle
6. Put the seal cover over the bottle cap.
Figure 4-8
Sealing bottle
7. Fill in the identification form (sticker) and apply it on the sample bottle (see Figure 4-9).
Figure 4-9
Identification form (sticker)
Lubrication charts in this manual may differ from the ones displayed on the vehicles. For lubrication
specifications, always refer to the charts on the vehicles.
Sealed sample
To Next Page
Loading...
