Labrie automizer Service Manual

Multiplexing 191
Gripper Open:Arm Too High Lower Arm
High Hydraulic Oil Temp. Turn Off Engine and Refer to your
Maintenance Personnel
Low Hydraulic Oil Add Hydraulic Oil
Packer Extend:Air Weigh Signal Unload Body
Packer:Already Extended Refer to Maintenance Personnel or
LabriePlus
Packer:Already Retracted Refer to Maintenance Personnel or
LabriePlus
Packer:Extend Too Long Check Extend Prox
Packer:Pump Not Started Engage Pump
Packer:Retract Too Long Check Retract Prox
Pump Not Started:Aux. Cab EStop Pull Out Aux. Cab EStop Button
Pump Not Started:Cab EStop Pull Out Cab EStop Button
Pump Not Started:Hopper Door Open Close Hopper Door
Pump Not Started:Main Air Pressure Let the Air Build Up to Required
Pressure
Pump Not Started:RPM Too High Lower Engine Speed Below
900 RPM
Pump Stop:Main Air Pressure Let Air Build Up to Req’d Pressure
Pump:Aux. AutoDump Switch ON Release Aux. AutoDump Switch
prior to Engaging Pump
Pump:Aux. ChuteToLeft Switch ON Release Aux. ChuteToLeft Switch
prior to Engaging Pump
Pump:Aux. ChuteToRight Switch ON Release Aux. ChuteToRight Switch
prior to Engaging Pump
Pump:Aux. CloseGripper Switch ON Release Aux. CloseGripper Switch
prior to Engaging Pump
Pump:Aux. Deadman Switch ON Release Aux. Deadman Switch prior
to Engaging Pump
Pump:Aux. OpenGripper Switch ON Release Aux. OpenGripper Switch
prior to Engaging Pump
Table 1 Warning messages (cont’d)
Warning and Caution Messages Solution

Labrie automizer Specifications

General

Brand	Labrie
Model	automizer
Category	Automobile
Language	English