Learjet 60 - Crew Compartment; Miscellaneous.-_

Pilot's Manual

Learjet 60
MISCELLANEOUSEQUIPMENT
CREW COMPARTMENT
FLASHLIGHTS
I
Flashlights
are located either on the Jeppesen
storage units or on
the
sidewall
next to the pilot's and copilot's
seats . The optional rechargea-
ble
flashlights are waterproof,
flame retardant, and floatable .
Three
flasl-light installation
options are available : rechargeable flash-
lights
may be installed with a
recharging base ; user provided
flash-
lights
may be secured with
hook and loop tape or mounted on
a two-
point retention bracket . The
retention bracket and hook and loop tape
act as a storage mount for any
appropriately sized flashlight .
Except
for the
recharging base, no aircraft
provided recharging capability
is
available with the hook and loop
tape or retention bracket
assembly
configurations . An optional 120
VAC adapter is available with
the re-
chargeable configuration
for use in an office or home outlet .
When the
flashlights are recharged
they could then be transferred to the reten-
tion brackets or
hook
and
loop tape installations onboard the
aircraft .
If a recharging base
is used, the flashlight must be
properly placed in
the retention
bracket for recharging . Ensure the
"D" ring is properly
secured
into the flashlight end cap . Place the
head end of the light
against
the retaining disc at the top end of the bracket
with the switch
toward the
bracket and the small red LED light facing
out . Once the
head of the
flashlight is positioned, snap the butt of the
flashlight into
the clips
at the bottom of the bracket . When the
flashlight is recharg-
ing,
the LED light should be on . To remove the
flashlight from the
bracket, grasp and pull the lower end of
the light out of the bracket
clips . Do not install the flashlight into the recharging base
while the
flashlight
is still turned on since recharging and lamp life would be
significantly reduced .
The lamp inside the flashlight
may need to be changed after approxi-
mately 20 hours of
service . To change the lamp, unscrew the head of
the light andremove the
lens cap and reflector assembly . Remove the
lamp from the reflector by unscrewing the threaded plastic retainer . In-
sert the new lamp and replace the retainer . Be sure to re-install the
spacer/washers to retain its highly focused lighting ability . Do not
touch the shiny surface of the reflector or the glass portions of the lamp .
If
the reflector surface requires cleaning, use only a soft, dry cloth .
7- 1 6

PM-123
Change 2