Learjet 60 - Airshow 400 Cabin Video Information System; Univision System

Learjet 60

Pilot's Manual
AIRSHOW 400 CABIN VIDEO INFORMATION SYSTEM
An optional Airshow 400 Cabin Video Information System may be in-
stalled . The system includes a
serial
mouse,
video monitor and
an
optional cockpit controller . The Airshow 400 system is selected for dis-
play bya membrane switch located on the forward right hand cabinet,
near the video monitor . This switch is normally labeled ASHW/VCR .
An additional switch is located in the passenger armrest .
The passenger briefing feature consists of three messages, (TAKEOFF,
LANDING and TURBULENCE) . To access these briefings, scroll
through the menu and select TimeTo Destination (TTD), select SEL
BRF
from the sub-menu if using the
optional
cockpit controller, or by select-
ing SEL BRF from the INFO MENU if using the serial mouse . After se-
lecting the desired briefing, the message will be heard through the
overhead cabin speakers and in each passenger headphone .
The brief-
ing will override any other audio source except for paging . To cancel a
briefing scroll to CANCEL or reselect the same briefing .
UNIVISION SYSTEM
An optional UniVision system from UASC may be installed . The cock-
pit control unit allows the crew to initialize and cancel UniVision stored
messages and briefings . The standard passenger briefings consist of
three messages (TAKEOFF, LANDING and TURBULENCE) . The
system is able to access up to sixty four separate safety
briefings
.
Brief-
ing
content is user supplied, however, UniVision supports audio and/
or graphics content for each briefing . "No Smoking" and "Fasten Seat-
belt" is presented as an animated graphic in a small pane on the cabin
monitor .
Briefings and messages are stored in the UniVision host computer and
are activated by the crew in the following manner . Rotate the SELECT
knob (either direction) until the desired briefing or message title
appears
in
the
eight
character
LED
display
window . Press the ENTER
button once to activate the cabin briefing or message . The LED display
will flash while the briefing is playing and becomes steady once the
briefing is completed .
Avoid pressing ENTER more than once . Doing so
NOTE

will start the briefing, stop it, and cause it to begin
again .
The briefing or
message
may
be
interrupted
at
any time by pressing the
CANCEL button . The audio portion of a briefing will also be canceled
when the cabin PA is keyed .
PM-123
Change 4
5-48C