Figure 55. Cable routing for server model with ten 2.5-inch SAS/SATA/NVMe drives, rear SAS/SATA drive assembly,
middle NVMe drive assembly and one 16i RAID adapter-2
Cable From To
9 SAS signal cable for front
backplane
SAS/SATA 0–3 and SAS/SATA 4–7
connectors on the front backplane
C0 and C1 connectors on RAID
adapter in PCIe slot 1
10 SAS signal cable for front
backplane
SAS/SATA 8–9 connector on the front
backplane
C2 connector on RAID adapter in
PCIe slot 1
Ten 2.5-inch SAS/SATA/NVMe drives, middle NVMe drive assembly and one 16i RAID adapter
Notes:
• The cable routing illustration is based on the scenario that the middle NVMe drive assembly is installed.
Depending on the model, the middle NVMe drive assembly might not be available on your server.
• The following two illustrations are for the same one configuration.
Chapter 2. Server components 65
To Next Page
Loading...
