Diagnostic information 2-107
7002-xxx
292.00 Error code service check
ADF cover open jam.
4
Motor driver card Turn the power off, and disconnect CN9 on the motor driver card.
Measure the voltages in the table below:
If incorrect, replace the motor driver card. If correct, go to step 5.
5
Second scan sensor—
electrical checks
Turn the power off and reconnect CN9 to the motor driver card.
Measure the voltages in the table below with the sensor in normal
operations (sensor closed) and with the sensor open (sensor flag
activated).
If the voltages are incorrect, replace the second scan sensor. If this
does not fix the problem, replace the complete ADF assembly. See
“ADF complete assembly removal” on page 4-15.
Note: Whenever the complete ADF assembly is replaced, it is
necessary to perform scanner registration. See “Scanner
registration” on page 4-4.
FRU Action
1 ADF upper top cover Check the ADF upper top cover to make sure it closes properly and
does not come loose or pop up while the ADF is scanning.
FRU Action
Second scan sensor—reflective type
(normally closed)
Connector CN9 (motor driver card)
CN9—Pin 4 0 V dc
CN9—Pin 5 +5 V dc
CN9—Pin 6 +5 V dc
Note: All voltages are approximate values.
Second scan sensor—interrupter type (normally closed)
Connector CN9 (motor driver card)
Pin number Sensor closed Sensor open
CN9—Pin 4 0 V dc 0 V dc
CN9—Pin 5 +1.16 V dc +1.16 V dc
CN9—Pin 6 +5.0 V dc +0.15 V dc
Note: All voltages are approximate values.
To Next Page
Loading...
