Diagnostic information 2-161
7002-xxx
Print quality—blank page
Print quality—random marks
Service tip: The primary cause of random marks is due to loose material moving around inside the printer and
attaching to the photoconductor, charge roll, or transfer roll.
Print quality—blurred or fuzzy print
Blurred of fuzzy print is usually caused by a problem in the main drive gearbox assembly, alignment assembly,
any feed roller, or in the transfer roll bearings or transfer roll. Check the gearbox assembly for correct operation.
Check the transfer roll for binds or a contaminated shaft or bearings.
Blurred print can also be caused by incorrect feeding from one of the input paper sources, paper trays, duplex
option, or envelope feeder.
Check the high voltage contacts to ensure they are not bent, corroded, or damaged. Replace as necessary.
FRU Action
1 Print cartridge Check the print cartridge for damage, especially the PC drum contact
on the cartridge.
2
High voltage contact Check the PC drum contact on the right side frame for damage, PC
drum contact wear or contamination. If the contact is bent or
damaged, replace the contact.
Note: Inspect the HVPS PC drum contact on the board for damage
or contamination.
3
HVPS Check the fuse on the HVPS. If open, replace the HVPS. Check the
voltages at J22 on the system board. Measure the following voltages
from connector J22 to printer ground:
• Printer Idle
J15-5 measures +24 V dc
• Printer Printing
J15-5 measures +24 V dc
If the voltages at J10-5 are incorrect, replace the system board.
4
Front cable harness HVPS
section
Check the front cable harness at J15 on the system board and at
CN1 on the HVPS to make sure the harness is connected properly. If
connected properly, check the continuity of the cable harness. If there
is no continuity, replace the front cable harness.
5
Printhead assembly Generally a 93x service error is posted if the printhead assembly fails
and the printer does not give a blank copy symptom.
The printhead used in the printer does not have a mechanical shutter
as previous laser printers. The printer is interlocked through the front
top cover interlock switch.
Symptom Action
1 Random marks Check the print cartridge for loose or foreign material that might be
on the photoconductor. Check the transfer roll and charge roll for any
pieces of material that are stuck to the rolls.
To Next Page
Loading...
