2-54 Service Manual
7002-xxx
58 Too many disks
installed
Model X646e only. The MFP detects an excess of hard disks installed.
1. Turn the MFP off.
2. Unplug the power cord from the wall outlet.
3. Remove the excess hard disks.
4. Connect the power cord to a properly grounded outlet.
5. Turn the MFP on.
58 Too many flash
options installed
The MFP detects an excess of optional flash memory cards installed.
Touch Continue to clear the message and ignore the extra optional flash
memory cards.
The message occurs again unless the excess optional flash memory cards
are removed.
1. Turn the MFP off.
2. Unplug the power cord from the wall outlet.
3. Remove the excess flash memory.
4. Connect the power cord to a properly grounded outlet.
5. Turn the MFP on.
58 .xx Too many trays
attached
The MFP detects that too many optional drawers and their matching trays
are installed.
1. Turn the MFP off.
2. Unplug the power cord from the wall outlet.
3. Remove the additional drawers.
4. Connect the power cord to a properly grounded outlet.
5. Turn the MFP on.
59 .xx Incompatible
duplex
An unsupported optional duplex unit is attached to the MFP.
Remove the optional duplex unit.
The MFP ceases normal functions until the optional duplex unit is removed.
Touch Continue to clear the message once the optional duplex unit is
removed.
59 .xx Incompatible
envelope feeder
An unsupported optional envelope feeder is attached to the MFP.
Remove the optional envelope feeder.
The MFP ceases normal functions until the optional envelope feeder is
removed.
Touch Continue to clear the message once the optional envelope feeder is
removed.
59 .xx Incompatible tray
[x]
An unsupported optional drawer and its matching tray are attached to the
MFP.
Remove the optional drawer.
The MFP ceases normal functions until the optional drawer is removed.
Touch Continue to clear the message once the optional drawer is removed.
61 .xx Remove defective
disk
Model X646e only. The MFP detects a defective hard disk.
1. Turn the MFP off.
2. Unplug the power cord from the wall outlet.
3. Remove the defective hard disk.
4. Install a new hard disk.
5. Connect the power cord to a properly grounded outlet.
6. Turn the MFP on.
User attendance messages (continued)
Code
Sub
code
Primary message Description/action
To Next Page
Loading...
