11. Appendix MX-FR Series Modular Matrix Frames – User's Manual 181
▪
4 line LCD) and the lightware protocol.
▪
▪ Control commands are not uppercased any more. This way lowercase characters can be used for
with lowercase or uppercase characters.
▪
MX-HDMI-OB card, the front right and front left channels will be present on the SPDIF output connector.
▪ Audio infoframes were lost when the display was turned off and on again (or removed and plugged in
▪
▪ Some displays (only known example is DELLU2410) didn't play audio correctly, if the signal was
▪ The matrix rebooted after a while if a display continuously pulled the hot-plug up and down.
3.2.8
Released: 2012-06-01
▪ In the MX-FR80R during the boot sequence the matrix reported a missing PSU as an error. It was a false
3.3.0
Released: 2012-08-16
New feature
▪ EDID reading is supported on both MX-HDMI-OPT-OB and MX-HDMI-OPT-IB card. Their behaviour is
same as other cards now (dynamic edids, edid switching, etc.)
▪
on the output port, if the serial passthru is disabled.
▪ MX-HDMI-3D-IB and MX-HDMI-3D-OB are supported.
▪ Omron SX51TX optical transmitter module (MX-HDMI-OPT-OB) has 0 default value for "waveform
select" as this proved to result better performance on shorter cables.
▪
loss with the HDMI-OPT- receiver device.
▪ Sometimes random 0x03 charachters were sent to odd MX-HDMI-OPT-OB serial ports.
3.3.1
Released: 2012-10-19
New feature
▪ MX-DVI-OPT-OB-RCLK SCH_2.2 support
▪ MX-3GSDI-IB now supports 3GSDI Level B signals: 1080p 50Hz and 60Hz
▪ If an output was connected to "input 0" (disconnected), then it was switched to input 1 after a front
panel-switching
▪
switches were not sent to the RS232 port.
▪ Connecting an output to input 0 (disconnected) when at least one dual link input card was present in
the router may have caused fatal crosspoint switching error.
▪ The Validity bit was set wrong in audio sample packets SB6 byte when PCM audio was transmitted.
▪
copyrighted (copy protected) material. Now the content protection is turned off on SPDIF outputs on
the MX-HDMI-OB card.
▪
professional application. This wasn't right for some professional SPDIF receivers.
▪
it is marked as consumer non-protected material because this prevents some SPDIF interoperability
issues.
▪ Digital signals with <40px back porch had sometimes strange recolor effects with MX-DVII-IB and MXD-
UMX-IB board.
▪
the input video signal source with the :DVII command again to auto or digital mode (DVII command
color conversion matrix.
▪
and the user set the input video signal source with the :DVII command again to auto or digital mode
audio was also muted for a while). This was because the TMDS clock was disabled while reapplying
▪
infoframes.
▪
from now: "IP: 192.168.2.68"
▪
▪
▪ MX-HDMI-3D-IB didn't work well with 4x20 character LCD display
To Next Page
Loading...
Need help?
General
