Linde H35D - Page 32

3 Overview
Indicator unit
NOTE
If a defective indicator unit is exchanged,
the operating hours up to that point must be
recorded. Affix the data on an embossed strip
near the indicator unit. There is also the option
of updating the new indicator unit at a later
time. Contact your authorised dealer.
(15) Operating hours symbol
Flashes when operating hours are being
counted (only when the ignition is on and the
engine speed exceeds 500rpm)
(16) Clock display
24-hour clock display.
Adjustable using the (18) and (19) buttons.
The diagnostics tester can be used to reset
the display to a 12-hour clock. Please contact
your authorised dealer.
(17) Service interval exceeded sy
mbol
If the number of operating hours until the next
service is less than or equal to 0, the symbol
flashes for 10 sec every time the vehicle is
started, and then lights up continuously.
Adjustment and reset of the intervals can be
performed only using the diagnostic device
provided for this purpose. Please contact your
authorised dealer.
(18) Function button
Assignment depending on version.
(19) Reset button
To adjust the time, switch off the wa
rning
buzzer and other functions dependi
ng on the
version.
(20) Symbol for Parking brake
Lights up when the parking brake is applied.
(21) Symbol for "Do not start engine"
Lights up when the engine has stalled.
NOTE
Always leave the ignition switched on until the
symbol goes out (between 15 and 50 seconds
depending on the oil temperature). Then try to
restart.
(22) Symbol for Operating hours until the next
service
After the ignition has been switc
hed on,
display field (14) shows the oper
ating hours
until the next service (counti
ng backwards).
Symbol (22) lights up. After 5 s, symbol (22)
goes out and indicator (14) automatically
switches to the operating hours of the truck;
the operating hours symbol (15) flashes.
(23) Lift mast position sensing symbol (special
equipment)
Lights up when the "Lift mast pos
ition detec-
tion" function is activated.
(24) Text field
Serves as display field. Please contact your
authorised dealer to read out the error codes.
If the particulate filter (additi
onal equipment) is
fitted and the particulate filte
r control system is
activated − residual capacity di
splay
The text field display involves 11 symbols:
• 0 symbols blacked out → no particulate filter
build-up,
• 6 symbols blacked out → approx. 50%
particulate filter build-up,
• 11 symbols blacked out → 100% particulate
filter build-up.
(25) Glow plug indicator (yellow)
Lights up whilst the glow plugs are wa
rming
up, then goes out.
Flashes when a fault exists in the engine or in
the engine control unit. Please contact your
authorised dealer.
(26) Air filter vacuum indicator (yellow)
Lights up when the air filter is exces
sively
clogged.
• Air filter clogged, exchange it.
(27) Cooling water level display (yellow)
Lights up when the coolant level is be
low the
minimum. If the "engine protection"
* function
22 Operating Instructions – 393 807 1001 EN – 08/2008