4 Operation
Special equipment
¾ Turn the rotary knob (5) in a clockwise direc-
tion against the stop and start the vehicle.
NOTE
If the vehicle does not start properly the first
time, the start procedure can be repeated (5)
until the rotary button is returned to the zero
position and the PIN number is discarded after
expiry of the delay time.
NOTE
If the green (2) and red (1) LED
both light up
continuously, the data must b
e read out. Ple-
ase inform your fleet manage
r at once.
Switch the vehicle off and log off:
¾ Turn the rotary button (5) anticlockwise as
far as it will go.
The engine is turned off.
NOTE
After a delay time (factory setting = 10 se-
conds) the red LED (1) lights up briefly, and
the green (2) and red (1) LEDs then flash for
approx. 3 seconds. During this period the ve-
hicle can be started at any time. The LEDs
then go out, and the PIN number is discarded.
The delay time can be set to between 10 se-
conds and 10 minutes using the diagnostic
device. Please contact your authorised dea-
ler.
Pressing the
#
button (3) after switching off
the engine terminates the delay time immedi-
ately and the PIN number is deleted.
80 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
