LNC T6 Series User Manual

LNC-Lathe New T6-Series
CNC Operation
LNC Technology Co., Ltd. 109
Details are as below：
1. IP：This address can not be repeated, otherwise the net will not be connected.
2. NET MASK：Please set this gnet mask the same with PC end.
3. GATEWAY：Please set this gateway the same with PC end.
After setting, shut down and reboot system, the NET setting is complete. You can wait for PC end to process
ReCON software to connect.
Controller and ReCON Connection
a. Controller and ReCON software first connection
when PC end’s ReCON software to connect with controller for the first time, controller will pop out below
dialogue, it will show IP address and ask if you want to connect to controller.
Press【Y】： Means you allow this IP’s PC to connect with controller from now on. At this time, connecting PC’s
IP will show on controller.
Press【N】： Means you are not allowed this IP’s PC to connect with controller, next time controller will not
accept any request from this IP.
Press【CANCEL】： Means you cancel this time’s connection from PC end. Next time, when PC end wants to
connect, it will show the same dialogue to ask your permission.

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English