LNC T6 Series User Manual

LNC-Lathe New T6-Series
CNC Operation
110 LNC Technology Co., Ltd.
b. Change connecting PC’s permissions.
This is the function for controller to define the permission of PC end. Move the cursor to this area and set
value from 1～3 and press INPUT, then you can change the permission. Setting value detail as below：
1：Set to be 1-only reading, connecting PC can only read, but can not write.
2：Set to be 2-reading and writing are all ok, connecting PC can read and write.
3：Set to be 3-means rejection. This IP’s PC is not able to connect with controller.
c. Cancel connecting PC’s IP address
If you want to cancel the Ip address, you can move cursor to this are and press INPUT to make the data to be
0. Next time when you connect to PC, it will show a dialogue again to request you fill up the IP address.
d. Check current connecting controller
you can check at『current connection』area to see if there is any PC connected to controller right now, if there
is IP address onit, it means right now has connecting PC. But if not, it means there is no connection. As for
ReCON connection detail, please refer to RECON relating setting chapters.

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English