LNC-Lathe New T6-Series
OP Panel Operation
118 LNC Technology Co., Ltd.
8. BDT
Control optional skip button, press this button to turn on, and press again to turn off. Those program’s head
with this mark ”/”, this line’s program will be skip.
9. AIR BLOW
Control air blow button, press this button to turn on, and press again to turn off.
10. W.L.
Control working lamp switch, press this button to turn on, and press again to turn off.
11. CTCH
Workpiece conveyor button, press this button to control conveyor.
12. CHIP
Control chip conveyor CCW button, press this button to turn on, until you release this button, the function will
stop.
13. CK
Spindle chuck button, press this button to control chuck.
14. TB IN
Tailstock ejector button, press this button to control tailstock ejector IN.
15. TB OUT
Tailstock ejector button, press this button to control tailstock ejector IN.
16. F1，F2
F1：This buttons are for machine makers to define.
F2：This buttons are for machine makers to define.
17. OT REL
OT REL is the short name of Over Travel Release. There is one limit switch at end of each traveling side of servo
axis in order to prevent to damage servo structure by colluding. When servo structure reaches traveling limit,
over traveling will occur, which implies emergency stop. When the screen has “EMERGENCY STOP OR OVER
TRAVEL” and this light is ON, please check whether or not the servo structure is over traveling. If it is over
traveling, change the mode to MPG or JOG mode first. Then pressing this light (let this light ON), so the
controller will ignore this over traveling emergency situation temporarily. This implies that users can use hand
wheel or axis-direction key to move servo axis back to the travel range. Releasing (OT REL) button at this time,
in order to let the system continue travel checking. If everything is working normally, which means “CNC Ready”
will replace “CNC Not Ready”, and then continue operating. If other warning messages occur, please press
[RESET] button before returning back to normal. Please be careful about moving direction, and moving speed
while moving the servo structure in order to prevent collusion.
Note: It is possible that over traveling situation occurs when “NOT Ready” condition occurs without any
prediction. Please put the over traveling condition into the checking item when searching for reasons
To Next Page
Loading...
Need help?
General
