LNC T6 Series User Manual

LNC-Lathe New T6-Series
RS232 COMMUNICATION SOFTWARE
LNC Technology Co., Ltd. 131
10.Screen change to [PROCHK] and NC end is at stand by mode, wait for PC end to transfer files.
11.Before press Send button at PC end, please make sure NC end is at stand by>Cycle-Start mode. In other
words, receiver must be prepared, so the sender can send out files, or after sending, press Cycle-Start to do
DNC.

LNC T6 Series Specifications

General

Brand	LNC
Model	T6 Series
Category	Controller
Language	English