LNC T6 Series - Page 4

LNC-Lathe New T6-Series
Table of Content
II LNC Technology Co., Ltd.
1.10.2 USROPT ...................................................................................................................... 102
1.10.3 TLIM ............................................................................................................................. 104
1.10.4 NET SET ...................................................................................................................... 105
1.10.5 【Change password】 ................................................................................................. 111
1.10.6 【Switch user】 ........................................................................................................... 112
2 OP Panel Operation ........................................................................... 113
2.1 OP ............................................................................................................................................. 113
2.2 LED SIGNAL ............................................................................................................................. 114
2.3 AXIS SELECTION .................................................................................................................... 114
2.4 MODE SELECT ........................................................................................................................ 114
2.5 SPINDLE ROTATION& SPINDLE SPEED ADJUSTMENT SWITCH ....................................... 116
2.6 Additional Function Selection ................................................................................................... 117
2.7 EMG-STOP ............................................................................................................................... 119
2.8 CYCLE START&FEED HOLD .................................................................................................. 119
2.9 Feedrate/Rapid Rate Adjusting Button ..................................................................................... 120
2.10 PROGRAM PROTECTION LOCK ............................................................................................ 121
2.11 POWER ON/OFF ...................................................................................................................... 121
3 RS232 COMMUNICATION SOFTWARE ............................................ 123
3.1 Transmission line preparation ................................................................................................... 123
3.2 PC end installation (use LNC ReCON 232 software) ............................................................... 124
3.3 NC end ...................................................................................................................................... 126
3.4 Communication （RS232）-【 DNC file upload and download functions 】 ........................ 140
3.4.1 Path Program Upload & save (using ReCON software) .............................................. 140
3.4.2 Path Program Upload & save (using ReCON software) .............................................. 143
3.4.3 Path Program Upload & save (using general software) ............................................... 146
3.4.4 Path Program Upload & save (using general software) ............................................... 150
3.5 Setting & Attention for USB to RS232 port ............................................................................... 155