Installation Guide
Connecting the LAN
Connect the CAT5 Ethernet cable with the RJ45 plug to the RJ45 socket of the
camera!
Connecting the Power
Connect the external power supply to the power cable of the camera!
Check the operation of the PTZ cameras
• Connect the Logipix PTZ camera to your computer and run the previously
installed SCPlayer by clicking on its desktop icon! Adjust the IP address of
the PTZ camera in the pop up window! The camera picture is going to be
shown immediately on the video monitor surface of the software.
• A unique solution has been developed for managing the Logipix PTZ
cameras, whereby the camera is movable remotely by the mouse. If
you click on the image of the camera, then it turns, so as the given
point will be the center of the picture. You can zoom by scrolling.
23/80
To Next Page
Loading...