Installation Guide
Controlling the Logipix Full HD PTZ
Controlling on the PTZ camera image
A unique solution has been developed for managing the PTZ cameras, whereby
the camera is movable remotely by the mouse. If we click on the image of the
camera, then it turns, so as the given point will be the center of the picture.
You can zoom by scrolling or using the scrollbar at the side of the image. The
image can be dragged and swiped by holding the left mouse button and
moving the mouse.
Controlling on the panoramic image
You can select a Logipix PTZ camera that you want to control by moving your
mouse pointer on the Logipix panoramic image. Click the pin icon in the lower
right corner of the PTZ camera picture.
Move your mouse pointer over the panoramic camera picture and hold the left
mouse button at least half a second (500ms) and after that draw around the
desired area. The selected PTZ is going to turn and zoom in according to the
marked image section. The image can be dragged and swiped by holding the
left mouse button and moving the mouse.
Controlling on the map
Move your mouse pointer over the map and click on an area! The selected PTZ
is going to turn exactly to the marked image section.
Saving pictures
1. Select the camera(s) which from you would like to save a still image or
images on the Video Monitor!
2. Pause the video stream!
3. Find the desired image! Use the video control icons!
4. If several images are selected at once, they are going to be saved
individually.
5. Click on the Save as picture icon!
76/80
To Next Page
Loading...