Installation Guide
Indicating Network Link – Activity Power – Ready
State1 Blinking in green
according to Ethernet
communication
Lights up in green if the
camera gets power
State2 Blinking in green and red
if the camera is ready to
use
LEDs of the Logipix PTZ cameras
• The LEDs can be found inside the camera enclosure. To make them
visible, you have to unscrew the hexagonal metal cover panel, which you
find at the front bottom of the horizontal rotating part of the camera
case. You can find the factory reset button on this panel as well near the
LEDs.
• After you have checked the LEDs screw back the hexagonal metal cover
panel!
LED1 LED2
Indicating Network Link – Activity Power – Ready
State1 Blinking in green according to
Ethernet communication
Lights up in green if the
camera gets power
State2 Blinking in green and red if
the camera is ready to use
Appendix A
Power supplies of the devices
36/80
To Next Page
Loading...