Installation Guide
Controlling the Monitor Profile
Watching live pictures
1. Open the Video Monitor! Click on its icon on the main surface of the
Control Center software!
At every Video Monitor launch or profile change the connecting information
are shown at the place of the camera pictures. Steps of the connection
procedure can be seen textually, and the camera name appears in between
round brackets. The green stripe below shows the course of the connection. If
the connection fails, then the stripe turns to red.
2. The previously created Monitor Profile is going to appear on the Video
Monitor which has been marked as the first in the order of the Monitor
profiles.
3. To change between the Monitor Profiles click on their buttons, which
can be found on the left section of the Video Monitor window.
Watching the archive
Archive video streams of all the cameras can be played back during the event
and also after the event has closed.
There are two ways to get the archive on the Video Monitor.
The first:
• Select those cameras on the Video Monitor which from you would like to
get the archives!
• Pause the video stream, then click on the Play backwards icon to play
reverse the archive from the actual time!
• Use the controller icons to navigate the archive playback.
73/80
To Next Page
Loading...