Installation Guide
Checking LED information
System LED states during startup:
LED States Description
System Lights up in red LNVR is starting up (it lasts
about 11.5 sec)
Lights up in yellow Initialization
Stays yellow for a
long time
There is no communication
with the motherboard (no
watchdog)
Lights up in green LNVR is ready, recording
LED states during operation
LED States Description
Pwr Lights up in green The camera gets power
through the 100 Mbit LPoE
port
Link Lights up in green Connection has realized
through the 100 Mbit LPoE
port
GIGABIT Link Lights up in green Connection has realized
through the Gbit port
Optical Link Lights up in green Connection has realized
through the optical port
System Lights up in red Switching off process has
started, or standby operating
mode
Blinking in RED Motherboard power failure
Blinking in yellow LPoE or HDD power failure
34/80
To Next Page
Loading...