Installation Guide
5. Right click on the Settings under the configured camera in the left tree,
and create a new Setup! Right click on it and Rename it!
6. If the new setup is selected, adjust the lower quality configuration for
after the event! This camera setup will operate when the Event has
closed.
Set the rest of the cameras as camera groups
1. Change the view of the device groups! Change to device type grouping
by signing the Device type radio button! Chose the camera type which
cameras you would like to configure at once! (Logipix 15MP camera /
Logipix Full HD PTZ camera / Logipix 2MP camera / analog camera /
analog PTZ camera)
2. Select the previously set individual camera in the device group in the left
tree and click on Settings with the right mouse button!
3. In the popup window, select Copy camera settings! The camera settings
and also the camera setups are going to be copied to the clipboard.
4. Select those cameras which for you would like to copy the given camera
settings and setups! The following individual camera parameters will not
be copied: Name; IP address; LNVR; Motion-masks and related settings,
Privacy and Exposition mask. Camera selection can be performed by the
very same method as file managing in Windows OS. To select
nonconsecutive cameras, hold down CTRL, and then click each item you
want to select. To select a consecutive group of cameras, click the first
item, hold down the SHIFT key, and then click the last item.
57/80
To Next Page
Loading...