Lorex ECO 2 User Manual

117
Appendix E: Internet Setup Wizard (PC only)
Configuring a DMZ host connection
• Connect to "Router 1" on your network (referred
t
o as "Possible 1st Router" in the Auto Port
Forwarding Wizard). Obtain the IP address of
Router 1. Usually this can be found in the
"Status" section of your router menu. The IP
should begin with "192.168...."This IP address is
your DMZ IP.
• Enter the IP address obtained from Router 1 into
the DMZ section of
Router 2.
• Once you have configured Router 2 with a DMZ
c
onnection, run the Auto Port Forwarding
Wizard to begin auto port forwarding to Router 1.
• Consult your router’s owner’s manual for details
on
configuring DMZ settings.
Example
DMZ stands for Demilitarized Zone. Enabling
a DMZ IP on your router enables one of the
routers to pass information onto the second
router.
DMZ IP address
assigned by a
secondary router
Locating your Router IP - The Status Page
Router IP assigned by
the main router. Enter
this IP into the DMZ
section of the primary
router.
The IP information is
normally under a
header called "WAN"
or "Internet Port".
Each router has
different terminology.
The "Status Page" of a router normally includes the router’s
vital information such as the IP address.
Locating your Router IP - The Status Page
EXAMPLE

Lorex ECO 2 Specifications

General

Brand	Lorex
Model	ECO 2
Category	DVR
Language	English