81
Remote Viewing Using a Web Browser
2 Configure the following:
• Channel: Sel
ect the channel that the PTZ camera connects to.
• Pr
otocol: Select the protocol of the PTZ camera*.
• Baud Rate: Sel
ect the baude rate of the PTZ camera*.
• Data B
it: Select the data bit rate of the PTZ camera*.
• Stop Bit: Sel
ect the stop bit rate of the PTZ camera*.
• Pa
rity: Select the parity settings of the PTZ camera*.
• Cr
uise: Select Enable or Disable*.
• Addr
ess: Select the address of the PTZ camera*.
*Consult the PTZ camera’s instruction manual for protocol and configuration details
3 Cl
ick Save to apply your settings.
Configuring the System Time and Date
To configure the system time and date:
1 Cl
ick the Remote Setting tab, and click System>General.
2 Co
nfigure the system format and time:
• Sys
tem Time: Enter the desired system time and date. An on-screen calendar appears when
you click the date.
• Date
Format: Select the desired format the date is displayed in.
• Ti
me Format: Select between 12 hour or 24 hour time formats.
3 Se
lect DST to enable daylight savings time, or NTP to sync the time with a NTP time server.
NOTE: Usin
g the NTP feature requires that your DVR have a constant Internet connection.
Changing the System’s Menu Time Out
To change the system’s time out menu:
1 Cl
ick the Remote Setting tab, and click System>General.
2 In the Menu Timeout dr
op-down menu, select the duration the menu stays on screen before
disappearing.
3 Cl
ick Save to apply your changes.
To Next Page
Loading...
