Chapter 12. Troubleshooting
262 3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2
Action
Install a compatible SO-DIMM on the controller.
See Also
For a list of SODIMMs compatible with the 9500S, search the LSI
KnowledgeBase for keyword 11748 at http://kb.lsi.com.
0039 Buffer ECC error corrected
Event Type
Warning
Cause
The controller has detected and corrected a memory ECC error.
Action
None required.
If errors persist, contact technical support at
http://www.lsi.com/channel/ContactUs
.
003A Drive power on reset detected
Event Type
Error
Cause
The controller has detected that a drive has lost power and then restarted. The
controller may degrade the unit if it is a redundant unit (non-redundant units
cannot be degraded).
Action
If this drive was the only one to lose power, check the cable connections.
Also, check that your power supply is adequate for the type and number of
devices attached to it.
See Also
For troubleshooting information and a link to drive manufacturer diagnostic
utilities, search the LSI KnowledgeBase for keyword 14927 at
http://kb.lsi.com.