Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-30Using SPM
2
! Verify that the filename chosen does not already exist.
The following screen appears only if the filename chosen already exists. Continue
with Step 7 if this screen does not appear.
! Observe the backup status screen.
SPM indicates the status of the backup by displaying the number of the last block
received (
YY). Line 2 of the display screen shows the estimated number of blocks to
be sent from the control unit (
YYY−YYYY). This line is blank if you are backing up from
Release 1.0.
If you abort the backup, the partial backup file is deleted to prevent restoration from a
corrupted file and you see the screen shown in Step 8.
When the backup is complete, you see the screen shown in Step 9.
7KHILOHDOUHDG\H[LVWV
,I\RXFRQWLQXHWKHROG
Press
0
to abort the backup. Go to
YHUVLRQZLOOEHGHOHWHG
Step 1 to create a different backup file.
3UHVV(6&WRDERUW
RU
 F  WRFRQWLQXH
Press
*
to continue. Go to Step 7.
3UHVV(6&WR$ERUW
filename = the backup filename specified
(VW%ORFNV YYY - YYYY
in Step 5
 GJMFOBNF
%$&.83,135 2*5(66
5HFHLYHG%ORFN YY

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English