MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-77Lines and Trunks
3
◆ Block Procedure
Console Display/Instructions Additional Information PC
! Specify the block of 20 lines associated with the 20 line buttons on the system
programming console.
Select
/LQHV
/LQHV
/LQHV
/LQHV
! Assign the queue priority specified.
Toggle the green LED on or off as required.
On = to assign the queue priority
Off = not to assign the queue priority
! Return to the System Programming menu.
Select
([LW twice.
QCC Operator to Receive Calls 3
Use this procedure to specify whether or not incoming calls on each line/trunk ring
into the QCC queue and to identify the QCC system operator positions that
receive incoming calls on each line/trunk.
NOTES:
1. This procedure applies to Hybrid/PBX mode only in a system that
includes QCC operator positions.
2. Each ground-start, loop-start, or automatic-in tie trunk programmed to
ring into the QCC queue can be associated with one or more QCC
operator positions.
3. If a trunk assigned to ring into the QCC queue is also used for shared
remote access, see “Remote Access Features” on page 3–502
for
instructions. You must assign remote access before you assign a QCC
system operator to receive calls. See “QCC Operator to Receive Call
Types” on page 3–379 for more information.
4. Do not change the factory setting of No QCC Operator Assigned to
Receive Calls for trunks dedicated to incoming calls for calling groups,
trunks used as personal lines, DID trunks, unequipped DS1 trunks, or
dial-in tie trunks.
To Next Page
Loading...
Need help?
General
