MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-639Memory Card
3
Restore 3
Use this procedure to restore system conditions that were backed up onto a
translation memory card. The information in a backup file on the translation card is
copied to the system.
The restore procedure is necessary under the following conditions:
■ System RAM is corrupt.
■ A previously stored set of system conditions is preferred over the current
set.
■ The processor module is replaced.
■ After a System Erase (frigid start) has been performed.
■ The system software has been reinstalled.
The Inspect feature (Inspct or
) is available to view the attributes of the
backup files on the memory card prior to initiating the restore procedure. The
attributes included on the Inspect screen are the filename, the time and day of the
file creation/update, the location of the system programming port, and information
about the system software release from which the backup was made.
If any type of programming is taking place at another extension when you begin
the restore procedure, the restore is canceled and the number of the first busy
extension appears on the screen. Repeat the restore procedure when the busy
extension becomes idle.
If a line is busy (incoming call or active call) when you begin the restore
procedure, the restore is canceled and the number of the first active line appears
on the screen. Repeat the restore procedure when the line becomes idle.
Also see “Restore Messages” on page 3–642
for information about errors that
may occur during the restore procedure.
Summary: Restore 3
Programmable by System Manager
Mode All
Idle Condition System Forced Idle
Planning Form Not applicable
Factory Setting Not applicable
Valid Entries Not applicable
Inspect Yes
Copy Option No
To Next Page
Loading...
Need help?
General
