Luna 4600 - Page 152

140 Chapter 7
Controlling the OBR Remotely
7
Description: Sets the gauge length in cm. This is the new name for
CONF:SRES {sensingResolution}. The CONF:SRES
command is still supported, but may be discontinued in the
future.
Response:
None
Examples: CONF:GLEN
1.5
Sets the gauge length to 1.5 cm.
CONFigure:GaugeLENngth?
Usage:
CONF:GLEN?
Description: Queries the gauge length. This is the new name for
CONF:SRES? {sensingResolution}. The CONF:SRES?
query will continue to be supported, but may be
discontinued in the future.
Response: Returns the gauge length in cm.
Example: CONF:GLEN?
This query returns the gauge length in cm.
CONFigure:SensorSPAcing
Usage:
CONF:SSPA
Description: Sets the Sensor Spacing in cm. The sensor spacing was
previously tied to the Sensing Resolution value, and both
were set by the
CONF:SRES command. It is now a separate
value with its own command.
Response: None.
Example: CONF:SSPA
2.0
Sets the Sensor Spacing to 2.0 cm.
CONFigure:SensorSPAcing?
Usage:
CONF:SSPA?
Description: Queries the Sensor Spacing.
Response: Returns the Sensor Spacing in cm.
Example: CONF:SSPA?
This query returns the sensor spacing in cm.