MAC155 Rev. 12 ©Copyright MAC Instruments 2005. All Rights Reserved.
Pg 18
CONTROLLER WIRING
Figure 9 – Rear Connections of MAC155 Controller
Figure 10 – Controller I/O Pin Designations
PROBE TO CONTROLLER WIRING
Using the supplied cables connect the controller to the probe. The rear of the
controller provides the appropriate connections. The wiring to the 3 pin “AC
Power to Probe” connector and the 6 pin “CONTROL I/O TO PROBE” is covered
in the PROBE WIRING section.
Figure 11 – Controller to Probe Connectors
To Next Page
Loading...