Mackie DL806 and DL1608 Reference Guide
110
BeforetappingtheYesbutton,let’sdiscusstheloadbuttonforamoment...butonlyforamoment!
Load—Loadisanoptionwedidnotseeinthe“CurrentShows”section.That’sbecausethecurrent
showistheloadedshow!Loadisonlyavailableinthe“OineShows”sectionandwillloadtheselected
show(includingallofthesnapshotsassociatedwiththeshow)astheCurrentShow.
Ok,nowtaptheYesbutton!
Afterloading,theCurrentShowwilldisplaytheHeadlinershowandallofitssnapshots.Nowtap
theOineShowsbuttontoseeanimagesimilartowhatisdisplayedbelow.NoticethatSupport
is no longer the green button...Headliner is!
Load time is all dependent on the number of stored snapshots on the show and it can take up
to two seconds per snapshot to transfer. The current state of the console is not changed on a show
load, audio still passes and you can still adjust all mix controls. However, in reality, you will probably
want to wait to recall a snapshot from the new show after loading the show completes.
Asareminder,loading a show will replace the current show on the mixer with the new show.
AllconnectediOSdeviceswillalsoloadthenewshow.Thiswillcreateacopyofiton
each iOS device so it may be used oine in the future, if needed.
Atthispoint,anewshowhasbeencreatedandnamed,butit’stimetocreatesomesnapshots.
Simplyfollowthesamestepsasyoudidfortheoriginalshow[Support-DirtyPots,page104].
That’sbasicallyit.Whentappinganunloadedshow[graybutton],theonlyotherchoicesinthepopover
includeDuplicate,Name,ImageandDelete.TherstthreeworkexactlyliketheydofortheCurrent
Show. If you need a refresher, please refer back to pages 103-104. Only Oine Shows may be deleted,
nottheCurrentShow.Solet’stakeaganderatDelete.
Delete—Asmentionedabove,thedeletebuttondeletesthecurrentlyselectedshowandallofits
snapshots. This is a permanent deletion with no undo, so a conrmation dialog helps prevent accidents.