Mackie DL Series Reference Guide

Mackie DL806 and DL1608 Reference Guide
106
Step 6 — Recalling snapshots: Nowthatyou’vecreatedandnamedthesnapshots,
it’stimetorecallthem! On recall, all appropriate console parameters change to match
the stored snapshot. In our example, recall each of the snapshots, starting with the Intro.
Tap the Intro button to reveal the popover as shown on the previous page, tap the Recall
buttontorevealaconrmationdialogasseentotheleft,thentaptheYesbuttontorecall
thesnapshot.Nowgobacktothemixerandchannelviews.Thesettingsyoucreatedfor
theIntrosnapshotwillberecalled.Dothesamethingwitheachsnapshot[Song1,Song2,Song3,etc.]
going back and revisiting the mixer and channel view each time to see the changes – wait for it – recalled!
Recallingsnapshot“0-Default”willsettheMasterFadertoitsdefault(which–forall
intentsandpurposes–isazeroedoutboard).Snapshot“0-Default”isalwayslistedrst
andcannotbereplaced,renamedordeleted;onlyrecalled .
Input and output channel linking may be stored and recalled in snapshots so that a pair of
channels could be linked in one snapshot and unlinked in another.
Channel Safes
On the right-hand side of the shows view are small channel safe buttons. Engaged selections
will be removed from snapshot recall, leaving the corresponding channels or outputs unchanged.
These will illuminate green when engaged and are gray when disengaged. The following are available
for channel safes:
•Channelinputs
 •Reverb[Controlsreverbsendandreturn]
 •Delay[Controlsdelaysendandreturn]
 •iPad
 •MainLR
 •Auxsends
When recalling a snapshot (including snapshot 0 - Default), the Master Fader app will not change any
 parametersonsafechannels.Channelsafesettingsareglobalandappliedtoallsnapshotsintheshow. 
They are saved and recalled with the show and recalled via power cycle.
 Channelsafeswillstillbeindividuallytouchableforeachchannelandoutputregardlessoflinkedstate. 
Linking or unlinking channels does not change the safe button states. If either channel of a linked pair
is marked safe in the shows screen, both will be treated as safe and not aected by the snapshot recall.
Similarly, when recalling a snapshot that unlinks the pair of channels, both will be treated as safe and
 notaectedbytherecall.Soifyougetitwrongnoharmnofoul;simplymarkbothassafeorneither
of the channels as safe and recall again.

Mackie DL Series Specifications

General

Brand	Mackie
Model	DL Series
Category	Music Mixer
Language	English