Always turn the starter switch to the “OFF” position at the end of work.
Use this switch to start and stop the engine.
• OFF
The key can be inserted and removed, the electrical
system current is turned off except the room lamp and the
engine stops.
• ON
Electricity flows through the charging circuit and lamp
circuit. Keep the switch at this position while the engine
is running.
• START
A position where the engine starts. Keep the key at this
position during cranking and when the engine has started,
immediately release your hand from the key. The key
automatically returns to the “ON” position.
The engine of this machine has the automatic remaining
heat function. If the engine does not crank when it is cold,
AUTO GLOW lamp illuminates. When the lamp
illuminates, wait until the lamp goes out and then, turn the
switch to the START position to start the engine.
position before operating the starter switch.
[2] FUEL ADJUSTMENT DIAL
Adjusts the engine speed and output.
• (a) Low idling (MIN): Position where the dial is fully
turned counterclockwise (left
direction)
• (b) Full revolution (MAX): Position where the dial is
turned clockwise (right
direction)
To Next Page
Loading...
