Maggi JUNIOR 640 - English; Table of Contents

To Next Page

To Previous Page

CONTENTS

CHAPTER 1

- GENERAL INFORMATION ..............6

1-1 OPERATING REMARKS .................. 6

1-2 DESCRIPTION OF THE MACHINE .. 6

1-2.1 USABLE TOOLS............................... 6

1-3 SAFETY PROTECTIONS ................. 7

1-4 INDIVIDUAL PROTECTION AIDS .... 7

1-5 TECHNICAL SPECIFICATIONS ....... 8

1-6 INTENDED USE ............................... 8

1-7 HANDLING AND HAULAGE ............. 9

1-8 CONTENTS AND PACKAGE ............ 9

1-9 DIMENSIONS ................................. 10

1-10 DIRECTIONS FOR INSTALLATION 11

1-11 DISCONNECTING PROCEDURE ... 11

CHAPTER 2

- INSTALLATION ..............................12

2-1 ASSEMBLING NOTES ................... 12

2-2 SPARE CLEARANCES AROUND

THE MACHINE ............................... 12

2-3 SETTING UP THE BENCH ............. 12

2-4 FITTING THE TOOL-HOLDING ARM

AND THE RELATED CONTROLS .. 13

2-5 FITTING THE TOOL-HOLDING

HEAD .............................................. 13

2-6 SETTING UP THE WORKTABLE ... 14

2-7 FITTING THE BLADE GUARD ....... 15

2-8 FITTING OR REPLACING THE

BLADE ............................................ 15

2-9 FITTING THE QUICK ARM POSITION-

ING LEVER "A" ............................... 16

2-10 CONNECTING THE SQUARING

MACHINE TO THE MAINS ............. 16

CHAPTER 3

- USE AND ADJUSTMENTS ............17

3-1 PERPENDICULARITY OF THE TOOL

TO THE WORKTABLE .................... 17

3-2 SQUARING THE ARM WITH THE

ABUTTING STRAIGHTEDGE......... 17

3-3 PARALLELISM OF THE BLADE WITH

REFERENCE TO THE CARRIAGE

TRAVEL .......................................... 19

3-4 RADIAL ADJUSTMENT OF THE

TOOLS ACCORDING TO THE

CUTTING ANGLES ......................... 19

3-5 TOOL TILT ADJUSTMENT WITH

REFERENCE TO THE WORKTABLE19

3-6 WORKTABLE PREPARATION........ 20

CHAPTER 4

- MAINTENANCE .............................21

4-1 ADJUSTING THE SELF-BRAKING

MOTOR BRAKING EFFECT........... 21

4-2 PERIODICAL LUBRICATION AND

CLEANING OF THE MACHINE ...... 21

4-3 REDUCING THE PLAYS ................ 22

4-3.1 CARRIAGE-SLIDEWAYS PLAY ...... 22

4-3.2 PILLAR-BASE PLAY ....................... 22

4-3.3 ARM-PILLAR PLAY......................... 22

4-4 NOISE EMISSION .......................... 23

4-5 OUT OF COMMISSION OF THE

MACHINE........................................ 23

CHAPTER 5

- ELECTRICAL DIAGRAM ...............24

5-1 MONOPHASIC MOTOR - MOTOR

SAFE-BOX ...................................... 24

5-2 WIRING CONNECTION TO TERMI-

NAL BOARD ................................... 25

5-3 THREE-PHASE MOTOR - MOTOR

SAFE-BOX ...................................... 26

5-4 WIRING CONNECTION TO TERMI-

NAL BOARD ................................... 27