IMPULSE•G+ Mini Advanced Instruction Manual - March 2014
3-4
• When using more than one transformer for the drive's power, properly phase each transformer.
• To reverse the direction of rotation, interchange any two motor leads (U/T1, V/T2 or W/T3;
changing R/L1, S/L2 or T/L3 will not affect the shaft rotation direction) or change parameter
B03.04.
• Use shielded cable for all low-level DC speed reference signals (0 to 10VDC, 4 to 20 mA).
Ground the shield only at the drive side.
• Please observe National Electrical Code (NEC) guidelines when wiring electrical devices.
NOTE: Failure to observe these warnings may result in equipment damage.
To Next Page
Loading...
