Magnetek 2001-G+M - Special Functions

IMPULSE•G+ Mini Advanced Instruction Manual – March 2014
5-16
Special Functions
The special function parameters are special crane and hoist specific functions used to control how
the system will operate. These include Quick Stop™ and Reverse Plug Simulation™. Listed below
are the special function parameters covered in this section.
• C1 Quick Stop
• C1 Reverse Plug Simulation
• C2 Micro Positioning
• C3 End of Travel Limit
•C3 Phantom Stop
•C3 Klixon
• C5 Load Check II
• C6 Swift-Lift
• C7 Torque Limit
• C8 Brake Answer Back
• C12 Brake Delay Timers
• C12 On/Off Delay Timers
• C12 Maintenance Timer
• C13 Inching Control
A01.01 = 02 (Advanced)
Traverse (00) Hoist (01) Braketronic (04)
Special Function V/f (00) OLV (02) V/f (00) OLV (02) V/f (00) OLV (02)
C1: Quick Stop


C1: Reverse Plug Simulation




C2: Micro Positioning


C3: End of Travel Limits 


C3: Phantom Stop 
C3: Klixon


C5: Load Check II    
C6: Swift-Lift
   
C7: Torque Limit
     
C8: Brake Answerback 
C12: Brake Delay Timers     
C12: On/Off Delay Timers

C12: Maintenance Timer 
C13: Inching Control   
D8: Dwell
    
: Available for the Motion selected
: Not available for the Motion selected