Malaguti Password 250 i.e. - Keyswitch

84
A
FRAME AND RUNNING GEAR
DISASSEMBLY
11/06
PASSWORD 250 i.e.5
B
V2
A
V2
A
• Replenish the radiator coolant and then close filler cap
(A).
• Start the engine and run it at IDLE speed for a few
minutes then switch off and unscrew the bleed screw
again to vent any residual air. Now retighten the bleed
screw.
KEYSWITCH
• (Remove sub-fairing).
• (Remove front half fairings).
• (Remove lower fairing).
• Detach connector (A) and disconnect transmission (B);
now undo screws (V2).
NOTE Use a TORKS (T. 25) wrench for tamperproof
screws to unscrew screws (V2).
Or a foolproof Allen wrench size 4.