Maytag MAT14CS - Installation Requirements; Tools and Parts

2-1
INSTALLATION REQUIREMENTS
For complete installation instructions
choose one of the links below.
TOOLS AND PARTS
Parts supplied:
Remove parts bag from washer. Check that all
parts were included.
2 inlet hoses
4 flat water hose washers
2 front-leveling legs with locking nuts
1 drain hose
1 hose clamp
1 service access door locking cam
PR units only: 1 Bezel Kit includes Bezel,
Harness wire.
CS units only: 1 coin slide extension and 2
mounting screws.
NOTE: Coin slide security bolt not supplied.
•
•
•
•
•
•
•
•
Gather the required tools and parts before
starting installation. Read and follow the
instructions provided with any tools listed
here.
Tools needed:
Level
Utility knife
Scissors
8” or 10” adjustable wrench
Flat-blade screwdriver
Pliers
Bucket
•
•
•
•
•
•
•
Installation Instructions
Commercial Non-Coin
Top Load Washer
Installation Instructions
Commercial Coin
Top Load Washer