3-3
SET-UP CODES
The LOWER MIDDLE key pad will advance
you from code to code.
The LOWER LEFT key pad will change the
code value.
The LOWER RIGHT key pad will select or
deselect options.
FOR PR MODELS: The set-up codes are
the same as for the ‘PD’ models except
where noted. The set-up code is indicated
by the one or two left hand characters. The
set-up code value is indicated by the two or
three right hand characters.
1.
2.
3.
4.
Refer to the tech sheet for a list of the set-up
codes by clicking on the link below.
IMPORTANT: The console must not be
opened unless power is first removed from
the washer. To access connector AA1:
Unplug washer or disconnect power.
Open console.
Disconnect plug on AA1,
Close console.
Plug in washer or reconnect power.
The washer is now in the set-up mode.
Before proceeding, it is worth noting that,
despite all of the options available, an
owner can simply choose to uncrate a
new commercial washer, hook it up, plug
it in and have a unit which operates.
3.
•
•
•
•
•
•
•
To Next Page
Loading...
