4-14
REMOVE THE METERCASE
Remove the control panel (see page 4-1).
Remove two - 5/16 inch screws from inside
the control cover assembly at the right end.
Remove two wire connectors from the
control board that go to the metercase.
1.
2.
3.
Two 5/16 inch hex screws
Two wire
connectors
Two - 1/2 inch
hex head bolts
Unlock and remove the service access door
on top of the metercase
Remove two - 1/2 inch hex head bolts at
the rear of the metercase that secure it to
the top of the washer.
4.
5.
The left bolt is shorter and secures to the
washer top. The right bolt is longer, it
passes through the washer top and secures
to the washer side panel.
6.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
To Next Page
Loading...
