4-23
REMOVE THE AGITATOR
7/16 inch bolt
Remove the cap on the top of the agitator
by prying the cap up off the agitator with
your fingers, or use a flat blade screwdriver
in the notch to pry the cap off while lifting
with your hand.
1.
Remove the 7/16 inch bolt that secures
the agitator and lift the agitator out of the
washer.
2.
Inspect the agitator bolt to ensure that the
rubber gasket is in tact and not cracked for
proper operation of the washer.
3.
Cap
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
To Next Page
Loading...
