6-3
TOP LOAD WASHER
HELP MODE
This mode is entered by pressing the LOWER
LEFT key pad while in special pricing option
mode 2.XX (or while dAS displays if operating
with Maytag Data Acquisition setup). In help
mode, the LOWER MIDDLE key pad can be
used to advance through three help codes
(displayed as 1h.XX, 2h.XX and 3h.XX).
Pressing the LOWER RIGHT keypad while
any of the help codes are displayed clears
the help codes. The help modes are followed
by the Energy Saving indication screen
(displayed as hE.ES), the Water Saving
indication screen (displayed as hF.LL),
the software version, and nally the water
temperature sensing screen (displayed as
Exxx). Press the LOWER LEFT keypad at any
time to exit help mode.
The Energy Saving and Water Saving
options are selected by default. The water
temperature sensing screen (displayed as
Exxx) is not a measure of water temperature
in °F, but higher numbers do correspond to
higher temperature water. In help mode, other
display symbols and elements are mapped to
reect the state of various inputs and outputs
as follows:
*. . .low voltage present (below about 90 VAC)
circle above digit . . . . . . . . . . . . . . . lid closed
SOAK . . . . . .water sensed at small load level
WASH . . . . . . . . . water sensed at wash level
RINSE . . .water sensed at highest water level
OR. . . . . . . . . . . . . . . . .motor sensed running
COLD . . . . . . . . . . . . . . . . cold water relay on
HOT . . . . . . . . . . . . . . . . . . hot water relay on
SMALL LOAD . . . . . . . . . . . . . .motor relay on
SPIN . . . . . . . . . . . . spin (reversing) relay on
To Next Page
Loading...
