66
Adjust Screen Brightness: Change the screen brightness using the manual control knob. . This is
only available in MVCT with integrated display or if they are controlled with an STVI
Set Logos: Allows user to set the logo to be used in the report. The file should be in ,bmp
format and placed into the root directory of a usb stick. Then insert the USB stick into the USB
port of the MVCT and hit the Set Logos button. This will copy and store the file and the logo will
be included on top of the report in the future
Ethernet: Enable and disable DHCP
Max Test Voltage: Set the maximum voltage the MVCT will output during any test
Saturation Curve Ramp Rate:
Please note that certain device settings will only be available for manipulation if the user
is running the PowerDB application on an STVI ( Smart Touch View Interface ) or on an
MVCT with integrated display. These settings include: Number Format, Adjust Screen
Brightness, Set Date & Time, and Logging. If the application is running on a standard PC
or laptop then these settings are adjusted within the PC’s operating system such as
Windows.
5.4.2.3 Nameplate Information
Selection of Name Plate Information, brings the user to the screen allowing the user
to input nameplate information. This screen will vary depending upon whether the MVCT is set for CT
Testing or VT Testing. The VT nameplate information screen below allows the user to input data about
the VT under test.
To Next Page
Loading...
